The part number 2090-UXBB-DM09 is a drive-mounted breakout board designed for the Ultra3000 drives. It is a component of the control interface breakout board series, which provides discrete wire termination for signals on the CN1 I/O connector of Ultra3000 drives. This breakout board is specifically designed for the CN3 Serial Connector and is intended for use with the Ultra3000 drives.
Technical Specifications
- Dimensions: The dimensions of the breakout board are not specified in the provided documentation.
- Cable Diameter: The maximum cable diameter that can be used with this breakout board is 29.0 mm (1.14 in.).
- Screw Terminal Wire Size: The recommended screw terminal wire size is 0.06…1.31 mm2 (30…16 AWG).
- Recommended Wire Strip Length: The recommended wire strip length is 25…63 mm (1.0…2.5 in.).
Alarm/Error Codes
No specific alarm or error codes are mentioned in the provided documentation for this part number.
User Manuals
The user manual for this part number is not explicitly mentioned in our research. However, it is recommended to refer to the Ultra3000 Digital Servo Drives Installation Manual, publication 2098-IN003, for additional information about the signals on the CN1 I/O connector.
Troubleshooting
Troubleshooting procedures for this part number are not explicitly mentioned in our research. However, it is recommended to refer to the Ultra3000 Digital Servo Drives Installation Manual, publication 2098-IN003, for troubleshooting information about the signals on the CN1 I/O connector.
Programming
No specific programming information is mentioned in the provided documentation for this part number.
Installation
The installation of this breakout board is described in the Motor Feedback Breakout Board Installation Instructions, publication 2090-IN006. The installation guide provides detailed instructions on how to install the breakout board, including the recommended cable diameter, screw terminal wire size, and wire strip length.
In summary, the part number 2090-UXBB-DM09 is a drive-mounted breakout board designed for the Ultra3000 drives, providing discrete wire termination for signals on the CN1 I/O connector. It is intended for use with the CN3 Serial Connector and is designed for use with the Ultra3000 drives. The technical specifications, installation, and troubleshooting procedures are detailed in the provided documentation.